Manual Settings for all Modems using ADSL or ADSL2+
Service Type: ADSL/ADSL2+
Port: DSL
Connection Type: PPPoA
VPI / VCI: 8 / 35
Encapsulation Mode: VC/MUX
Username: yourusername@ezybroadband.net.au
Password: your ezybroadband password
Authentication Method: AUTO
IPv4 Address: Static (enter your static IP address in the available field)
Obtain DNS: Automatically
If manual DNS entries are required by your modem, use:
Primary: 103.5.90.253
Secondary: 103.5.91.253
MTU: 1500
NOTE: If your modem/router has ALG (application layer gateway) features, please ensure that you disable both the SIP ALG and the h.323 ALG because these will cause problems if you're planning to use VoIP.
Quality of Service (QoS) Configuration for VoIP
Go to Network setup > QoS > QoS Policy Select “Add entry” and configure the...
Billion BiPac VDSL Modems | ezynbn Settings for FTTN (fibre to the node)
Service Type: VDSL on PTM Interface...
Manual Settings for all Modems using VDSL (for NBN)
Service Type: VDSL Port: DSL Connection Type: PPPoE Priority: -1 (not required) VLAN...