Client Zone Knowledgebase ezybroadband Connect a Cisco Meraki MX to the NBN

Connect a Cisco Meraki MX to the NBN

Print
nbn, router, pppoe 0

This guide connects a Cisco Meraki MX security appliance to our NBN service through the NBN box, using PPPoE on the MX's Internet port.

Updated 21 November 2026Applies to Meraki MX routers

What you'll need

  • Your NBN username and password, from the welcome email we sent
  • A computer connected to the router by cable or Wi-Fi
  • The router's sign-in details, usually on a label underneath it

Your NBN settings

Connection typePPPoE
UsernameAs supplied, for example yourname@ezynbn.net.au
PasswordAs supplied
IP addressGet it automatically. If your router has a field for a fixed IP address, enter the static IP address we supplied.
DNSAutomatic. If your router needs them entered: 103.5.90.253 and 103.5.91.253
MTU1492
VLANOff, for most businesses. If you use VLANs: VLAN ID 100, priority 0

Set up the Meraki MX

  1. Open the local status page

    From a computer connected to the MX, go to setup.meraki.com and sign in (username admin, and the MX's serial number as the password on current firmware).

  2. Choose PPPoE

    On the Configure tab, set the connection type to PPPoE, turn on authentication and enter the username and password. Save.

  3. MTU

    Nothing to do: Meraki fixes the PPPoE MTU at 1492.

VLAN

VLAN or no VLAN? If you're not sure, you don't need one: leave VLAN settings off. Use VLAN ID 100 only if your business uses VLANs, or the person who looks after your network asks for it.

No VLAN (most businesses)

Leave VLAN tagging off on the uplink.

Using a VLAN

Turn on VLAN tagging on the uplink and enter VLAN ID 100.

Phones behind the MX: Meraki's MX has no SIP ALG, so there's nothing to turn off for VoIP. Meraki recommends a traffic shaping rule that gives voice high priority.

Still not working?

  • Check the username is the whole address, including @ezynbn.net.au, and retype the password.
  • If you turned on a VLAN, try again with it off (or the other way round).
  • Restart the NBN box and the router, then wait two minutes.
  • Still stuck? Open a ticket with your router's make and model, and a photo of the lights on the NBN box.

What's next

Steps follow Cisco Meraki's documentation: "Support for PPPoE on Cisco Meraki Devices", the local status page guide, "Troubleshooting MTU Issues" and the VoIP FAQ (November 2026).

Was this guide helpful?

Still stuck?

Send us the details and our team will take it from here

Open Ticket