Client Zone Knowledgebase ezybroadband Connect a TP-Link router to the NBN

Connect a TP-Link router to the NBN

Print
nbn, router, pppoe 0

This guide connects a TP-Link Archer router to our NBN service. For fibre, HFC and fibre-to-the-curb, plug the router's WAN port into the NBN box. For fibre-to-the-node or building, you need a TP-Link with a built-in VDSL modem, plugged into the phone socket.

Updated 21 November 2026Applies to TP-Link routers

What you'll need

  • Your NBN username and password, from the welcome email we sent
  • A computer connected to the router by cable or Wi-Fi
  • The router's sign-in details, usually on a label underneath it

Your NBN settings

Connection typePPPoE
UsernameAs supplied, for example yourname@ezynbn.net.au
PasswordAs supplied
IP addressGet it automatically. If your router has a field for a fixed IP address, enter the static IP address we supplied.
DNSAutomatic. If your router needs them entered: 103.5.90.253 and 103.5.91.253
MTU1492
VLANOff, for most businesses. If you use VLANs: VLAN ID 100, priority 0

Set up the TP-Link

  1. Sign in to the router

    Open the router's web page in a browser and sign in. The address and password are on the label underneath the router.

  2. Open the Internet settings

    Go to Advanced > Network > Internet.

  3. Choose PPPoE

    Set the connection type to PPPoE, then enter your username and password from the table above.

  4. Set the MTU

    Select Advanced Settings on the same page and set MTU Size to 1492. On some models it's under Advanced > Network > WAN.

  5. DNS, only if needed

    To enter DNS by hand, choose Use the following DNS addresses and enter the two addresses from the table.

  6. Save and restart

    Select Save, then restart the router from Advanced > System > Reboot.

VLAN

VLAN or no VLAN? If you're not sure, you don't need one: leave VLAN settings off. Use VLAN ID 100 only if your business uses VLANs, or the person who looks after your network asks for it.

No VLAN (most businesses)

Leave the IPTV/VLAN settings switched off.

Don't pick the "Australia-NBN" option if your router offers one in its IPTV settings: it turns on VLAN 100.

Using a VLAN

In Quick Setup, open Special ISP Settings (IPTV/VLAN), choose Custom, enter VLAN ID 100 and tick 802.1Q Tag. On older models, the Australia-NBN option in the IPTV settings does the same.

Fibre to the node or building (VDSL models)

On a TP-Link with a built-in modem, run Quick Setup: choose your region, pick Other in the ISP list, set L2 Interface Type to VDSL, tick Enable VLAN ID only if you use a VLAN (ID 100), then set Internet Connection Type to PPPoE and enter your details.

Still not working?

  • Check the username is the whole address, including @ezynbn.net.au, and retype the password.
  • If you turned on a VLAN, try again with it off (or the other way round).
  • Restart the NBN box and the router, then wait two minutes.
  • Still stuck? Open a ticket with your router's make and model, and a photo of the lights on the NBN box.

What's next

Steps follow TP-Link's support FAQs 2415, 1134, 1712, 1766 and 5410 (November 2026). Menus vary a little between models.

Was this guide helpful?

Still stuck?

Send us the details and our team will take it from here

Open Ticket