This guide connects a Fortinet FortiGate to our NBN service through the NBN box, using the WAN interface's PPPoE mode.
What you'll need
- Your NBN username and password, from the welcome email we sent
- A computer connected to the router by cable or Wi-Fi
- The router's sign-in details, usually on a label underneath it
Your NBN settings
| Connection type | PPPoE |
|---|---|
| Username | As supplied, for example yourname@ezynbn.net.au |
| Password | As supplied |
| IP address | Get it automatically. If your router has a field for a fixed IP address, enter the static IP address we supplied. |
| DNS | Automatic. If your router needs them entered: 103.5.90.253 and 103.5.91.253 |
| MTU | 1492 |
| VLAN | Off, for most businesses. If you use VLANs: VLAN ID 100, priority 0 |
Set up the FortiGate
Set the WAN interface to PPPoE
Go to Network > Interfaces, edit the WAN port and set Addressing mode to PPPoE. Enter the username and password, then select OK. Fortinet offers this in the web interface on its smaller models; on others, use the CLI commands below.
DNS, only if needed
Go to Network > DNS, set DNS Servers to Specify, enter the two addresses and select Apply.
Or use the CLI
Open the CLI console from the dashboard and use the commands under the VLAN tab that matches you. Replace
wan1with your WAN port's name.
VLAN
VLAN or no VLAN? If you're not sure, you don't need one: leave VLAN settings off. Use VLAN ID 100 only if your business uses VLANs, or the person who looks after your network asks for it.
No VLAN (most businesses)
config system interface
edit "wan1"
set mode pppoe
set username "yourname@ezynbn.net.au"
set password "yourpassword"
next
end
Using a VLAN
config system interface
edit "nbn-vlan100"
set vdom "root"
set interface "wan1"
set vlanid 100
set role wan
set mode pppoe
set username "yourname@ezynbn.net.au"
set password "yourpassword"
next
endUpdate your firewall policies. With a VLAN, internet traffic leaves through nbn-vlan100, so your outgoing policy must use it in place of wan1.
Still not working?
- Check the username is the whole address, including
@ezynbn.net.au, and retype the password. - If you turned on a VLAN, try again with it off (or the other way round).
- Restart the NBN box and the router, then wait two minutes.
- Still stuck? Open a ticket with your router's make and model, and a photo of the lights on the NBN box.
What's next
- Disable SIP ALG: FortiGateGet the router ready for your phones
- NBN settings for any routerThe settings, for any make of router
Steps follow Fortinet's FortiOS 7.6 administration guide (interface settings, interface MTU and DNS).