Client Zone Knowledgebase ezybroadband Connect a MikroTik router to the NBN

Connect a MikroTik router to the NBN

Print
nbn, router, pppoe 0

This guide connects a MikroTik router running RouterOS 7 to our NBN service through the NBN box. It uses a few commands, pasted into the router's Terminal, because they're the same on every MikroTik model.

Updated 21 November 2026Applies to MikroTik routers

What you'll need

  • Your NBN username and password, from the welcome email we sent
  • A computer connected to the router by cable or Wi-Fi
  • The router's sign-in details, usually on a label underneath it

Your NBN settings

Connection typePPPoE
UsernameAs supplied, for example yourname@ezynbn.net.au
PasswordAs supplied
IP addressGet it automatically. If your router has a field for a fixed IP address, enter the static IP address we supplied.
DNSAutomatic. If your router needs them entered: 103.5.90.253 and 103.5.91.253
MTU1492
VLANOff, for most businesses. If you use VLANs: VLAN ID 100, priority 0

Set up the MikroTik

  1. Open Terminal

    Sign in to the router with WinBox or WebFig and open Terminal.

  2. Check which port goes to the NBN box

    The commands below assume the NBN box is plugged into ether1. If you used a different port, change ether1 to match.

  3. Paste the commands for your set-up

    Use the VLAN tab below that matches you, with your own username and password in place of the examples. MikroTik sets the PPPoE MTU to 1492 automatically.

  4. Check it's connected

    Under PPP > Interface, pppoe-nbn shows R (running) once it connects.

VLAN

VLAN or no VLAN? If you're not sure, you don't need one: leave VLAN settings off. Use VLAN ID 100 only if your business uses VLANs, or the person who looks after your network asks for it.

No VLAN (most businesses)

/interface pppoe-client add name=pppoe-nbn interface=ether1 user="yourname@ezynbn.net.au" password="yourpassword" add-default-route=yes use-peer-dns=yes disabled=no
/interface list member add list=WAN interface=pppoe-nbn

Using a VLAN

/interface vlan add name=vlan100-nbn interface=ether1 vlan-id=100
/interface pppoe-client add name=pppoe-nbn interface=vlan100-nbn user="yourname@ezynbn.net.au" password="yourpassword" add-default-route=yes use-peer-dns=yes disabled=no
/interface list member add list=WAN interface=pppoe-nbn

Using a custom firewall? The second command adds the connection to the router's WAN list, which MikroTik's default firewall and NAT use. If you've replaced the default configuration, add pppoe-nbn to your own rules.

Still not working?

  • Check the username is the whole address, including @ezynbn.net.au, and retype the password.
  • If you turned on a VLAN, try again with it off (or the other way round).
  • Restart the NBN box and the router, then wait two minutes.
  • Still stuck? Open a ticket with your router's make and model, and a photo of the lights on the NBN box.

What's next

Commands follow MikroTik's RouterOS 7 manual (pppoe-client and PPPoE pages, version 7.26).

Was this guide helpful?

Still stuck?

Send us the details and our team will take it from here

Open Ticket